Common faults and maintenance methods of ice maker(Part 2)
Ice maker fault 4: the water shortage light is on but the machine does not automatically feed water
Maintenance method: check the water inflow of the pipeline. If there is no water, open the water circuit and restart the machine. If the water inlet solenoid valve is faulty, replace it immediately.
Ice maker fault 5: the power indicator keeps flashing fast and the machine does not work
Maintenance method: open the rear cover plate of the ice maker, open the electrical control box cover above the compressor, find a three core connector, check whether the water temperature probe of the ice maker falls off or has poor contact, and if so, plug it again.
Fault 6 of ice maker: the water in the spray pipe is not smooth, and some ice pieces are incomplete
Maintenance method: check whether the spray pipe hole of the ice maker is blocked. If it is, use tweezers or other sharp things to clean the debris on the water outlet hole of the spray pipe under the ice making running water state until the running water in each hole is unblocked.
1. The problem of icing inside the refrigerator may be that many consumers have some wrong methods when using it. For example, the food itself is still steaming, but it is directly put into the refrigerator. Because the internal temperature of the refrigerator is relatively low, when it is cold, water vapor will form, which will cause the problem of icing on the inner wall.
1. Preventive measures can be taken. For example, if the food is still steaming, it can't be put in directly. It can be put in only when it is cold. If you want to preserve fresh vegetables, wash them thoroughly, drain the water, wrap them in plastic bags or wrap them with plastic wrap, and then put them in. This can not only lock the water, but also help the use of the refrigerator, so as to avoid the problem of icing.